TIP: As soon as the opener activates, DO NOT press any additional buttons until the opener stops running. On the keypad, press the UP/DOWN key once every two seconds until the opener operates again. With the keypad LEDs still flashing, press the LEARN/PROGRAM button on the opener again for 2-3 seconds and then release.Ĩ. If you do NOT have one of these openers, programming of Opener #1 is complete.ħ. ONLY IF YOU HAVE A Chamberlain®/LiftMaster®/Craftsman® opener with a YELLOW LEARN button, please complete #7 & #8 below. All other listed names and trademarks are the property of their respective owners. Genie® and Intellicode® are registered trademarks of The Genie Company. On the keypad, press the UP/DOWN key once every two seconds until the opener operates.On the opener, press the LEARN/PROGRAM button for 2-3 seconds and then release.On the keypad, press and release the UP/DOWN key (LED flashes rapidly).On the keypad, enter the ID# of the opener from Chart A.On the keypad, press and release the UP/DOWN key (LED flashes slowly).On the keypad, enter a personal PIN (3-8 digits).NOTE: Steps #7 & #8 required for Chamberlain®/LiftMaster®/Craftsman® unit YELLOW LEARN button ONLY To start over at any time, start at STEP 2 - CLEARING THE KEYPAD. You will need your opener ID# from Chart A for these steps. This keypad can be programmed to up to 3 individual garage door openers in any combination of manufacturer specifications. If the opener/receiver has dip switch technology, please move to the alternate instructions listed on our website at this time: STEP 3 - PROGRAMMING TO ONE OR MORE OPENERS
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |